Simple Installation Instructions

Here are really simple instructions for building and installing Shairport Sync on a Raspberry Pi B, 2B, 3B or 3B+. It is assumed that the Pi is running Raspbian Stretch Lite – a GUI isn't needed, since Shairport Sync runs as a daemon program.

Configure and Update

Do the usual update and upgrade:

# apt-get update
# apt-get upgrade
# rpi-update

(Separately, if you haven't done so already, consider using the raspi-config tool to expand the file system to use the entire card.)

Activate the Improved Audio Driver

Check the file /boot/config.txt and, if it's not there already, add the following line:

audio_pwm_mode=2

Turn Off WiFi Power Management

If you are using WiFi, you should turn off WiFi Power Management:

# iwconfig wlan0 power off

WiFi Power Management will put the WiFi system in low-power mode when the WiFi system considered inactive, and in this mode it may not respond to events initiated from the network, such as AirPlay requests. Hence, WiFi Power Management should be turned off. (See TROUBLESHOOTING.md for more details.)

Reboot the Pi.

Remove Old Copies

Before you begin building Shairport Sync, it's best to search for and remove any existing copies of the applicatioon, called shairport-sync. Use the command $ which shairport-sync to find them. For example, if shairport-sync has been installed previously, this might happen:

$ which shairport-sync
/usr/local/bin/shairport-sync

Remove it as follows:

$ sudo rm /usr/local/bin/shairport-sync

Do this until no more copies of shairport-sync are found.

Build and Install

Okay, now let's get the tools and sources for building and installing Shairport Sync.

First, install the packages needed by Shairport Sync:

# apt-get install build-essential git xmltoman autoconf automake libtool libdaemon-dev libpopt-dev libconfig-dev libasound2-dev avahi-daemon libavahi-client-dev libssl-dev

Next, download Shairport Sync, configure it, compile and install it:

$ git clone https://github.com/mikebrady/shairport-sync.git
$ cd shairport-sync
$ autoreconf -fi
$ ./configure --sysconfdir=/etc --with-alsa --with-avahi --with-ssl=openssl --with-systemd
$ make
$ sudo make install

Now to configure Shairport Sync. Here are the important options for the Shairport Sync configuration file at /etc/shairport-sync.conf:

// Sample Configuration File for Shairport Sync on a Raspberry Pi using the built-in audio DAC
general =
{
  drift_tolerance_in_seconds = 0.010;
  volume_range_db = 50;
};

alsa =
{
  output_device = "hw:0";
  mixer_control_name = "PCM";
};

The next step is to enable Shairport Sync to start automatically on boot up:

$ sudo systemctl enable shairport-sync

Finally, either reboot the Pi or start the shairport-sync service:

$ sudo systemctl start shairport-sync

The Shairport Sync AirPlay service should now appear on the network with a service name made from the Pi's hostname with the first letter capitalised, e.g. hostname raspberrypi gives a service name Raspberrypi. Connect to it and enjoy...

3.2 KiB Raw Blame History Unescape Escape